51711R 1/8 Alloy Taper RC Nitro Engine Air Filter Red

51711R 1/8 Alloy Taper RC Nitro Engine Air Filter RedUpgrade air filter to increase performance by allowing your engine to breath easier. Hard wearing alloy filter housing. Great for off roading. Includes spare air filter sponge. To fit engines carbs 13 18mm outer diameter. Includes cable to ties to secure. Will stretch slightly to fit 18mm carbs.

70mm Internal Diameter

- Two sets of mounting points

Hard wearing alloy filter housing with secondary top metal filter and small thin air flow holes to catch larger bits of dirt

Not suitable for use with turbo glow plugs

8mm Hex Fitting - 25mm Length - 25mm High - Note: Center of pull starter is held together with tape when installing remove the tape and ensure the center does not pop out

- Engine base 13mm between side by screw holes and 22mm to the furthest away screw hole (total of 3 screw mounting points)

May fit other cars below is the measurements please check before ordering

408mm Long 160mm Wide 110mm High 250mm between center of wheel arches Includes no extra decals

9mm Internal Diameter (hole in the middle)

7mm inner diameter

5mm - Wing length end to end 167mm

To check these wheels will fit your model please check measurements below: 105mm External Diameter - 71mm Internal Diameter - 42mm Width - 12mm hex hub - 20mm edge of wheel to edge of hex hub