51911S 1/10 Scale RC Alloy Silver Adjustable Exhaust Pipe Muffler Two Chamber

51911S 1/10 Scale RC Alloy Silver Adjustable Exhaust Pipe Muffler Two ChamberTwo chamber exhaust pipe with adjustable inner chamber. Splits down the center, the inner chamber is threaded allowing the fuel outlet to be positioned wherever best suits on the exhaust. Inner chamber features several holes (see picture) with adjustable inner piston allowing you alter how the exhaust performs and uses the second pipe. Measures 137mm long end to end.

48mm inner diameter

Same material as most of body shells made from

Please check measurements before ordering wont fit all 1/16 models

280mm Wheel Arches

No servo horn included or screws etc just servo as pictured

Suitable for some 1/8 models

5-13mm without gasket on

Two headlights and two rear red brake lights installed

Please check measurements to ensure a correct fit

16mm offset (measured from the edge of the wheel to the edge of the hex)

17mm Drive Hex

12mm hex hub 56mm inner diameter (check the hub carrier is smaller than this) 84mm outer diameter