Universal Qi Wireless Charging Transmitter

Universal Qi Wireless Charging TransmitterWe've added a ton of Qi receivers but, until now, we haven't had a charging base. No longer! This is a super simple Qi transmitter. It will work with any standard Qi charger receivers like the ones we carry here. You just connect the board to a 5v power supply either through a micro USB port then put your device w Qi receive onto the base. If you want to 'share' the microUSB power connection, you can also connect direct to the USB A port Maximum

and while it is flexible

5A or more during the high-current print -our 5V 2A power supply will work very nicely

• On-board ST-LINK/V2-B

general-purpose motor controllers for brushed

via serial commands sent to the device’s virtual serial (COM) port

but it's always best to avoid long-term (over 1 hour at a time) submersion

If you know how to peel off a banana

available in any office or stationery supply store

you'll need 8 digital data lines and 4 or 5 digital control lines to read and write to the display (12 lines total)

Collision Sensor *1

B+ and A+ and comes fully assembled with a treasure trove of examples to get you started

Low power module - only 20mA current draw