Trimpot Variable Resistor - 3386

Trimpot Variable Resistor - 3386Description Trimmer Trimpots is a high accuracy variable resistor and pcb mountable with 3 terminal pins. The voltage between the terminal varies as the trimpot is rotated. The Variable resistors are used for variating voltage as per the need in a circuit. The outer two pins are connected to Vcc and 0V, and center pin outputs a variable voltage between 0 v and Vcc as the rotary cermet is rotated. Features Specifications: Track Resistance: 100 K ohm

sensor readings can be up to 2 seconds old

simply shut down the Pi 3 B+

7809 is a linear voltage regulator IC

the basic pulse width may be extended by retriggering the gated low-level-active (A) or high-level-active (B) inputs or be reduced by the use of the overriding clear

The LM35 does not require any external calibration or trimming to provide typical accuracies of ±1⁄4°C at room temperature and ±3⁄4°C over a full −55 to +150°C temperature range

high-performance CMOS 8-bit microcomputer with 8K bytes of Flash programmable and erasable read only memory (PEROM)

Arduino code

8 MHz for Maximum speed

Peak Spectral Response Wavelength 850nm

sensor networks

SRAM Bytes:1

Panel PCB Dimension: Approx