N10163 1/8 M17 17mm Wheel Hex Hub Extension Adapter Alloy Blue x 4 30mm 12mm Cap

N10163 1/8 M17 17mm Wheel Hex Hub Extension Adapter Alloy Blue x 4 30mm 12mm Cap17mm Light Blue Extension Adapter x 4 12mm Thread. This will fit some 1 8 models. Please check measurements below before ordering as this will not fit all. Simply replaces the normal 17mm hubs with these extensions. Great if intending to put larger wider

so will need a few holes drilled in the center roof of your shell plus one larger hole directly in the middle of the bar for the wires to feed through

Suggested methods of powering LEDs are to use a 3rd channel on your receiver or a battery port or failing that a separate 6v battery pack

130mm wide

4 Amber LEDs

Motor and Electronic Speed Controller for 7

- Second mount point is at the side of the engine they are 10mm apart (two mount screw holes on either side of the engine)

Total length end to end 118mm

For 5 male and 5 female connector with 10 male and 10 female pins

- factory settings for needles

74mm total length

Holes come pre drilled at 90mm across center of fixing holes

Note: starter designed to fit SH engines or similar size (measurements above) SH starters dont feature a plate to secure the center string wheel