Sensor pack

Sensor packIncludes Triple axis analog accelerometer for measuring motion and tilt Force sensitive resistor for sensing pressure force Temperature sensor for measuring from 40 to over +125 degrees C 10K breadboard potentiometer Hall effect sensor for sensing a magnet Magnet for use with the hall effect Piezo can be used as a buzzer or a knock sensor Ball tilt sensor for sensing orientation Photo cell sensor for sensing light IR sensor for sensing infrared light

a 270° base motion

Current requirements: ~215 mA (transmit)

(2) 10-pin 2mm sockets - these are soldered into the board

Check the polarity and insert the batteries in the proper orientation

3V regulator that can handle the 350mA peak current

we were able to deliver short durations (on the order of milliseconds) of 30 A and several seconds of 20 A without overheating

tablet to watch the print progress from the convenience of your living

Infrared Obstacle Avoidance Sensor *1

The table to the right compares the Arduino Uno to Orangutan robot controllers

Uses common 4-40 hardware that can be found at most local hardware stores

or 18v25 versions with 24 V batteries

1 Code Walk-through