L-004 1/10 Scale Body Shell Direct Roof Mount RC Police Light Bar LED Rotational

L-004 1/10 Scale Body Shell Direct Roof Mount RC Police Light Bar LED RotationalTo suit 1 10 scale model car or truck shells. This is a direct roof mount so will need a few holes drilled in the center roof of your shell plus one larger hole for the wires to feed through. This is powered by either a direct 6v input (no batteries included) or by a spare port on your receiver. The connector type is male JR. Note: Input by a voltage higher than 6v DC will damage the unit. Light bar measures 68mm x 13mm between fixing points

To suit SMT 1/8 scale models

78mm inner diameter (aprox)

2 x blue gaskets

When the wheel is spinning these will light up automatically to avoid battery drain its recommended to remove these after use

4mm wide - outer diameter 28

Includes 1 x1

Whats included

Includes adapters to fit 23T 24T 25T Measures 27mm end to end furthest measured on 1 arm 18mm between center of servo cog to center of screw furthest measured on 1 arm

Includes a spare set of red springs (pictured)

Please check measurements to ensure a correct fit

Includes 17mm hubs

1/10 and 1/8 model cars and buggies work station in alloy blue