electronic overload relay for motor TeSys - 5...25 A - 24 V AC/DC

electronic overload relay for motor TeSys - 5...25 A - 24 V AC/DCTeSys LR97D electronic overcurrent relay, 25A 690V, to be supplied with 24V AC DC, for protection of motors with a rated current 5 21A. It provides 3 dials to adjust the protection, LOAD (5 25A) for the overcurrent level, O TIME (0. 3 10sec) for the acceptable duration of the overcurrent, D TIME (0. 5 30sec) for the starting duration. In addition, the device trips when the current is higher than 3 x LOAD during more than 0. 5sec in steady state and if

This product integrates Modbus serial line communication protocols as standard

It is a 2P

1A 125V AC / 30V DC

This K1 ammeter switch is ideal for switching between phase current measurements on a switchboard

This product is compatible with TT and TN earthing system

making it as resistant as possible

The operational current is 800A (AC23A) and the operational voltage is 690V 50/60Hz

for 3-pole contactors LC1D09-D38 (with screw clamp terminals)

The ECO COM BCM ULP module is limited to the transmission of metering data and status

669mm deep

It prevents the door from opening when the device is in On position but it can desactivated by adaptation

The cables must be centered within the toroid and the diameter represented by all these cables should not exceed 25 millimeters