T10066 1/8 RC Buggy M17 17mm Alloy Wheel Hubs Adapter Nut Pin Purple x 4

T10066 1/8 RC Buggy M17 17mm Alloy Wheel Hubs Adapter Nut Pin Purple x 4Set of 4 replacement wheel hubs to fit 1 8 scale models. This set includes hubs nuts and pins. This set does not use grub screws to secure the pins in place. When the wheel is over the hub the pin will be held in place. Inner diameter measures 8mm. Length of the hub 13. 3mm. 17mm hub measured across the flats. 12mm across the threads

Save your model from crashing with this fail safe in the event of loss of radio signal or low battery the fail safe will automatically switch the throttle servo (or steering servo if you chose) back to its preset positon like brake or to lower the revs on the engine saving you ££ off crashes

Each set consisting of 1 male and 1 female connector Measurement taken from internal diameter of the female bullet connector not wired end

Atomic Warhead and many more

Foam inserts not included these are just replacement tyres

59mm width

Other sizes available please ask

Hub thickness: 5mm

5 red female

1 x manifold 30mm long - 1 x gasket (not pictured but included) - 1 x silicone joint 38mm (not pictured but included) - 1 x manifold spring (not pictured but included)

100mm long between center of screw fixing holes

jpg Links are to pictures alone

26mm wide Edge of wheel to edge of 12mm hex center is 15mm