Borg Warner S400 - 4.62 , Marmon & Garret GT42 (T4) Turbine housing flange & Clamp Stainless and Aluminum

Borg Warner S400 - 4.62 , Marmon & Garret GT42 (T4) Turbine housing flange & Clamp Stainless and Aluminum4. 62 Turbine outlet flange & clamp fits S400, GT42, John Deere,S400 Marmon, and 3x3 T4 ONLY!!!!! See our S400 K31 listings For T6 Chargers Available in 4. 00" tube size only Available In 304 Stainless and 6061 Aluminum With or without Clamp As always made right here in the USA!!!!!

These are for the mounting of your angle grinders on wall near your work bench or anywhere you need

With the factory press fit grease fitting in the bottom there are no bushings or bearing to fail or wear out

Available in CR mild steel or 304 Stainless steel

14" wide at the top

005 oversized hole for use with any standard tube and match up with any of our custom intake cover plates

If your engine has the EPS / VGT sensor present you can use one of our 2006 -2013 6

2- Steel powdercoated sides plates

**ALL NOTCH KITS ARE NOW AVAILABLE

1-  -8AN Braided black bypass line with Black fittings installed on both ends

All Mild Steel Spacers now come standard with Black Zinc Plating for rust resistance

8 hole-   24"

These plates also allow you to relocated your MAP sensor and your boost gauge port closer to where the boost is actually effective