PSM E46 LimitBreak super angle front end set

PSM E46 LimitBreak super angle front end setListing is for: 1x Pair of Lower Control arms 1x Pair of Knuckle adapters 1x Pair of Outer Tie rods 1x Pair of Inner Tie rods or Non M model E46. 70 degrees parallel, or 75 & 65 degrees at full ackerman, with fine tuning in between can be achieved with this LimitBreak setup. Unlike common L shaped Front lower arms, our fresh approach replaces all factory style bushings & joints with low torque spherical bearings for precision and freedom of motion.

1x Eccentric lock out kit

the First 2" harness uses steel pull up adjusters on the lap belts and steel / aluminium adjusters on the shoulder belts

3 piece system slips together and is held together with included springs/tabs

Whether during assembly

Pure lead plates mean more power

If you want to use a larger vent line than AN-6

Diameter : 320mm

The front brake lines removed from the ABS block all T together as well

Elastic wrist closure and ankles with velcro straps to improve fitting—two large-sized pockets on the front and a front pocket with a zipper on the chest

This knuckle will not bolt onto the car without our Z33SAK lower parts set and Z33FUA upper arm

~ Can be adjusted longer OR shorter than stock

The 30mm roll center corrected drop knuckle restores handling geometry lost on lowered cars & has caliper options like our front knuckles: Either OEM foot-brake and Z32 hand-brake OR dual Z32 reproduction calipers we sell for $215/pair loaded