Stainless Racking Arm

Stainless Racking ArmThis Racking Arm for yeast free transferring of beer to kegs help you to maximize beer recovery and minimize yeast in your kegs. Insert this in the racking port of the fermenter before the valve, and use it when racking beer into kegs. The fitting has a sturdy lever that can be used to rotate the arm downward (loosen the clamp just slightly) until it starts to pick up yeast that has settled at the bottom of the fermenter, at which point the valve is

7 BBL 8hL Craft brewery complete brewing system including brewhouse will brew up to 120BBL/year (28000pints) on each three week fermentation cycle in the one fermenter that is included with the 7 BBL brewhouse system

2” clamps and silicone gaskets (2)

(55cm/22" outside diameter)

How to produce consistent

patented design is the only brewing system where the entire process (mashing

The available sizes range from small pilot volumes to larger commercial production sizes

The pressure gauge might not read anything unless there is back pressure (see link below for details)

Patco 376 or Atmos 300k)

Note: the standard adjustable trolley width for the SER geared trolley is 58-127mm

These commercial immersion hot water heaters come with a ceramic head (most competitors are made of plastic) which is impervious to heat and the connector contact is embedded in the ceramic (most competitors have the connector contact secured only by the weld to the heating rod)

What sizes are available

this removable neoprene rubber insulating jacket will keep your conical fermentor temperature more stable and reduce sweating when cold crashing or lagering