Fusion Bonded Chiller to Fermenter Hose Connecting Assembly

Fusion Bonded Chiller to Fermenter Hose Connecting AssemblyThis complete hose assembly kit is for connecting the BREWHA fermenter to the Fusion Bonded Chiller Heat Exchanger for knocking down wort temperature quickly after boil. The Pilot Hose Assembly (Fusion Bonded Chiller to Fermenter) is for connecting the Medium and Large Pilot Brewing Systems to the Fusion Bonded Chiller. The 1. 5BBL Hose Assembly (Fusion Bonded Chiller to Fermenter) is for connecting the 1. 5BBL Brewing System to the Fusion Bonded

two sanitary analogue temperature probes (measuring the temperature of it leaves the top of the fermenter and as it is returned at the bottom of the fermenter after it has been cooled)

with a couple allen/hex wrenches the four securing screws and one handle screw can be removed

This is the only brew boil kettle system with a built-in chilling jacket for easy

we recommend the Workstation Gantry that we list above

Its secure fittings provide a leak-proof connection

Then open the bottom discharge spout and empty grain into the Colander

The pump should not be run dry at any time

Cold side inlet / outlet temperature / pressure drop: 4°C/27

two sanitary valves

for increased production capacity just add additional 3 BBL stainless conical unitank fermenters (new model BIAC® 5-in-1s) and use the one Mash Colander in each additional fermenter on brew day

Easy addition of an electric immersion water heating element kits under the mash screen for RIMS brewing setup

SOOW power cables are engineered to be portable