Fermenter-to-Keg Racking Transfer Hose

Fermenter-to-Keg Racking Transfer HoseUse this hose assembly to easily transfer beer from a conical fermenter into a keg. The hose assembly attaches the racking valve on the fermenter to the 'Out' post on a keg, transferring beer directly to the bottom of the keg through the dip tube spear avoiding oxidation and unnecessary agitation. By setting the regulator on the CO2 tank to 1 2psi of pressure (up to 14psi on the 4 in 1 fermenters) and connecting the gas tank to the top port on the

Dimension listed is the height with lid off

these chillers allow you to pour multiple beverages

5m/5' of premium 1" stainless coil silicone hose with hose barb fittings and hose clamps

ball valves and sanitary tri-clamp fittings

Volume: 1700L / 450USG

Makes it easier to connect a blow off hose to the gas off port

removing all the grain with it while the wort drains out the bottom into the fermenter where it is ready for boiling

Heating and cooling equipment for brewery temperature-control components

Do not connect this 1 HP pump to a BREWHA BHPBWT single-heater controller used with pilot brewery systems

simplify sanitation

Increase brewery capacity simply by adding additional 5-in-1 BIAC stainless conical fermenter unitanks

NEW layer of permanent insulation and outer layer of stainless cladding for lower energy cost and lower crashing temperature