PSM E36 Sway Bar Reinforcement

PSM E36 Sway Bar ReinforcementListing is for: 1x Set of reinforcement plates Our 1 8" steel pates weld in to the E36 non M rear subframe to prevent the swaybar tabs from ripping off due to using aftermarket swaybars. The second bolt hole is specifically for our 2 bolt bar mounts although its compatible with any swaybar mount. Fits perfectly because of the 3D scanned and laser cut design. Sold as a set of 4 pieces.

Eliminates the need for jumper cables or another vehicle for assistance

Grayston GE55 FIA Master Battery Cut Off

Use together with a Stainless Steel single ear hose clamp 10

They eliminate the need for an external surge tank which would otherwise be needed when running a fuel cell

Body made of high strength

~ Unprecedented angle clearance even with zero Ackerman

In-tank convoluted black nylon fuel hose

Non fireproof lining for extra durability

After alignment is set

so would be a good choice for use on Z33 with slightly extended track width or just for more thread overlap between inner and outer tie rods

E46 323 325 328 330 M3 and Z4

~ Bell shaped high surface area pillowball side spacers reinforce subframe mount & give freedom of PB motion