PatternPly® Acrylic Solid Black on Red, one sided for backlighting

PatternPly® Acrylic Solid Black on Red, one sided for backlighting1 8 transparent red acrylic with black on one side. Glows red when illuminated from behind. Engrave on the black side. NOT DIODE FRIENDLY ~12 x 19. 2 Settings: Set material to Medium Clear Acrylic Cut: 168 full Engrave: default but change focus to 0. 325 in These settings are a starting point. Always test a small area of the sheet before starting a project in case further fine tuning is necessary for your laser.

the mirrored acrylic cores use an extruded acrylic

For the 4x8 cut your way selection

This item is for a single sheet of PatternPly in the specific swatch # listed at the beginning of the product name above

Sizing: All sheets are 12 x 19" except the 12 x 18" White Flex

Pantone 123

Glows white when illuminated from behind

the back of the leatherette sheet will be black

for example

Pantone 273

If you need wood sooner

Cut Settings: Cut Settings can be found here

Instead of the typical clear area in between the pattern elements