Insta-Cure™ Super Thin Glue - 2oz

Insta-Cure™ Super Thin Glue - 2ozInsta Cure has a water thin viscosity that wicks deep into joints by capillary action and cures in a matter of a few seconds. Surfaces to be bonded must be tight fitting and should be held together while you apply the CA around the edges of the seam. At the moment CAs cure, they give off a vapor that can irritate the nose and eyes, so be prepared. Thin CAs work very well on balsa since they penetrate into the wood and form more than just a surface

and light scratches without fillers

Allow 20-30 minutes before fill and recoat with Cardinal Pore Fill and Lacquer

Refrigerate to extend shelf life

Those who want to minimize neck weight

Three point pivoting front jaw

Use with a polishing foam pad with a rotary or dual action polishing machine

Click here for complete installation instructions

The 1st grade are quartersawn

The long handle provides excellent leverage for a clean cut

Turn off the machine and use the spring loaded ejector pin to remove the plug- then repeat

bond closely-fitted parts

The speed on the wheel should be between 750-1000 rpm