1938 1939 Ford Passenger Car Steering Column Tube (Pass. Car Only)

1938 1939 Ford Passenger Car Steering Column Tube (Pass. Car Only)Now available is a brand new steering column for 1938 1939 Ford Passenger Car. These tubes are made from thicker 18 gauge tubing rather than the very thin factory used 20g. Harder to dent, harder to bend and no more concern about the column drop crushing your steering tube. Since the wall thickness of the tubing is thicker, the bottom end of the tube is bored out to the original inside diameter in order for it to fit over the steering box. The outside

* Sold individually

but I recommend cutting out the damage and welding these in place

each panel was prepared and treated with a weld thru primer to prevent corrosion between these overlapping panels

You will receive two wiper covers that are without the two holes for the windshield wiper controls

Finally available are the female floor sockets which serve as the attachment points for retaining the carpet or mat to the #1 floorboard in all 1932 Fords

1936 and 1937 Ford pickups and trucks

This piece was design to repair those pesky cracks at the twelve o’clock position on the rear fenders

These are the inside cab mount reinforcement plates for the rear mounting points on 1935

Please make sure to select the correct style you are looking for

Check out our other products for Early Ford v8 cars and trucks

This tube is not the same as the one used in Pickups

1932 Ford replacement grille bars